|  contact

Cutting Saw 72/350

Machine for cutting long, cylindrical tubes or rods made of glass, quartz glass, porcelain, ceramics and similar material.

Item number: VT1-00219

Machine for cutting long, cylindrical tubes or rods made of glass, quartz glass, porcelain, ceramics and similar material with diameters 5mm to max. 130 mm and a length up to 2.500 mm. By one-time turning of the working piece also larger diameters of up to max. 200 mm can be cut.

The unit is designed for cutting discs of 400 mm diameter.

 

Machine base:

Complete base frame in solid steel welded pipe construction made of stainless steel. The machine bed is stress-free annealed and sand blasted. All mounting areas are processed treated. Four vibration isolating and sound-absorbing machine feet serve for the  optimum adjustment and alingment of the cutting saw.

 

Cooling water supply:

Closed cooling water cycle. Coolant reservoir with submersible pump is placed in the machine frame. The coolant reservoir is made of stainless steel and front removeable out of the support frame. Optionally the cooling water supply can be carried out by means of a magnet valve with fresh water supply. See catalogue number 72/351.

 

Protection device:

The cutting basin is completely made of stainless steel and set into the base frame. Additional splash protections are mounted at operator’s side and mounted below the working piece support. Two removeable strainers prevent that in case of glass breakage, glass is entering into the coolant.

 

Cutting device

The cutting aggregate in steel welded execution is traversable placed on a rocker. By waving the cutting device in the bearing shaft, the cutting wheel is  plunged into the working piece. Via an adjustable counter weight, an optimum weight distribution is provided, thus a constant feed pressure can be generated via the control lever. The key button inserted in the ball knob of the control lever synchronously switches-on  the cutting spindle and the cooling water pump.

 

Cutting spindle

The drive is carried out via an AC motor in connection with a Poly-V belt drive. The bearing of the cutting spindle is protected against ingress of dirt and water  by means of a well-proven labyrinth-sealing. A cutting disk protection is mounted at the corrosion-protected spindle with spindle ball bearing. Via a locking pin, a removeable lid at the cutting disk protection and a  spindle arrester allow a simple and fast exchange of the saw blade.

 

Working piece support with length limitation

A welded construction base support inclusive 2 piece removeable support prisms with clamping serve as working piece support. For a tidy application of the product, a silicon round cord is inserted into each individual prism. At the cutting position two firm cutting supports are available which are additionally  provided with an excentric height adjustment in order to optimally adjust the working piece. Right from the saw blade, a length limitation with measuring ruler is mounted.  Same is axially adjustable via a linear bearing and lockable in each position by means of a clamping. For fine adjustment, a shift slide with fine adjustment 0.05 mm at the stop is mounted. Optionally additional moveable support prisms can be offered.

 

Electronic execution

The main terminal box is mounted on the rear side of the machine base  and equipped with a CEE socket 16A for the water pump. The main switch and the EMERGENCY-STOP switch with housing are mounted at operator’s side.

 

Options:

the cooling water supply can be carried out by means of a

_ magnet valve with fresh water supply

 

Downloads

Manual

Download this manual as PDF-Document.